ReVit Microdermabrasion Skin Tightening

Whether you’ve already purchased your ReVit and are ready to get started, or are curious to learn more about the extraordinary power of diamond microdermabrasion, read on for step-by-step instructions for use.

ReVit microdermabrasion kit setup

1. Remove the ReVit exfoliation machine and other components from the box.

1. Choose the Filing Tip you require:

– Coarse – for heavy duty exfoliating
– Medium – for a gentler treatment
– Fine – for delicate finishing

1. Plug the power cord into the ReVit device socket.

1. Plug the other end of the power cord into an electrical outlet.

Your ReVit diamond tip microdermabrasion machine is now ready for use.

Skin microdermabrasion treatment process

The skin should be clean, dry and free of any powders, antiperspirants or deodorants. Pretreat your skin by washing your face with soap and water.

Begin facial microdermabrasion treatment

1. Give the ON BUTTON one short press. The device is now on Partial Suction Mode and is ready for use
2. Hold the device firmly from its GRIP area, making sure your hand does not block the AIR VENTS
3. If you wish to increase the suction intensity level, press once on the ON BUTTON to increase the level from Partial to Full Suction Mode
4. Apply the FILING TIP to the skin, making sure the skin is spread evenly and smoothly and the TIP is in full contact with the skin covering skin areas and neck area
5. Hold the Silk’n ReVit like a pencil, glide its tip to the skin and slowly run it over the treatment area for full coverage, following the suggested strokes below.

We recommend you start with the lower suction intensity and increase it after a few uses, depending on your comfort level and skin sensitivity.

Treat each area with two to four passes.

1. Using smooth, downwards strokes, work the neck area, forehead, cheeks and chin.
2. Firmly stroke from the center outwards, towards the hairline.
3. Continue down towards the face border, and then eyes and nose area.
4. In the area of the eyebrows, use short and upwards strokes, carefully avoiding the sensitive eyelids.
5. Continue to the nose area, use straight downwards strokes following the curve of the nose and the line of the cheekbone.
6. At the end of the treatment session, turn the device off by giving the ON BUTTON one quick press if you are on Full Suction Mode, or two quick presses if you are treating on Partial Suction Mode.

Post treatment

Rinse your face with cool water and apply moisturizer.

Replacing the filters
The need to replace filters on the ReVit varies by individual. You will know when to replace the filter when the device suction doesn’t feel as strong. This is due to the build-up of dead skin cells.

When you remove the filter, you will be able to see the build-up and know it’s time to install a replacement filter.

Want to learn more about the effects of the ReVit? Visit our Frequently Asked Questions page.